8" Triangle 30/60 degrees with Circle Templates
(AT-186)
Aluminum
triangles are useful for their short, straight edges
in finishing out the pre-trim process on a glass
table. The holes are useful as trim guides for cutting
precise holes in film to fit cleanly around circular
hinge bolts and other hardware found on movable vent
wings and swing-out rear quarter windows.
Back
to top
|
36" Straight Ruler
(AT-182)
These
longer aluminum straight edges permit straight cuts on glass
cutting boards and are also useful for creating the splices
on large commercial panes when "butt-splicing" is
required to yield a relatively seamless appearance.
Back
to top
|
18"
Straight Ruler (AT-183)
These longer
aluminum straight edges permit straight cuts on glass
cutting boards and are also useful for creating the splices
on large commercial panes when "butt-splicing" is
required to yield a relatively seamless appearance.
Back
to top
|
12"
Triangle 45/90 degrees with Circle Template (AT-187)
Aluminum
triangles are useful for their short, straight edges
in finishing out the pre-trim process on a glass
table. The holes are useful as trim guides for cutting
precise holes in film to fit cleanly around circular
hinge bolts and other hardware found on movable vent
wings and swing-out rear quarter windows.
Back
to top
|
Film Handler 72"
(AT-911)
Used
for making precise horizontal and vertical cuts in window
film from any roll width up to a maximum of 72 inches. It
has at least 2 vertical slitters for rapid, simultaneous
cutting of narrow strips for multi-piece rear windows.
Slitting injector blades are hidden and recessed for safety.
Can be affixed to a six-foot aluminum step-ladder for
in-shop or on-location cutting at commercial job sites. An
essential professional tool to reduce waste and speed
installations with straight & square cuts on all four
sides. (Ladder not included.) This
is a special order item, please call for availability.
Back
to top
|
Film Handler Assembly
(AT-912)
This
is the blade holder assembly for the Film Handler (AT-911).
This
is a special order item, please call for availability.
Back
to top
|
12" Risers
(AT-913)
12"
risers and 6" core adapter set for the Film
Handler AT-911. This is a special
order item, please call for availability.
Back
to top
|
Box Slitter Channel
(AT-822)
72
inch-aluminum U-channel for sliding over the edge of a film
box-top to serve as a straight edge when making horizontal
cuts (across the web width) after pulling film out to
desired length. Handy for in-field work. Saves the cost more
expensive film cutters. This is a special
order item, please call for availability.
Back
to top
|
Blade Holders
(AT-821)
Used
with the AT-822. These devices enable razor blades to be attached
to the Box Slitter Channel to permit vertical cuts up the
roll as the film is pulled from the box. Thumbs screws
loosen/tighten to allow blade holder to be slid to any
position along the channel. This is a
special order item, please call for availability.
Back
to top
|
|
|
