measurement tools.

measure twice, and cut once with these professional grade measurement tools.


Everything you need to complete your window film installations, our window film tools are specially selected to ensure quality installations. We offer a variety of tools, so choose from the categories below to see more. You can also download a printable PDF catalogue.


8" Triangle 30/60 degrees with Circle Templates (AT-186)

Aluminum triangles are useful for their short, straight edges in finishing out the pre-trim process on a glass table. The holes are useful as trim guides for cutting precise holes in film to fit cleanly around circular hinge bolts and other hardware found on movable vent wings and swing-out rear quarter windows.

36" Straight Ruler (AT-182)

These longer aluminum straight edges permit straight cuts on glass cutting boards and are also useful for creating the splices on large commercial panes when "butt-splicing" is required to yield a relatively seamless appearance.

18" Straight Ruler (AT-183)

These longer aluminum straight edges permit straight cuts on glass cutting boards and are also useful for creating the splices on large commercial panes when "butt-splicing" is required to yield a relatively seamless appearance.

12" Triangle 45/90 degrees with Circle Template (AT-187)

Aluminum triangles are useful for their short, straight edges in finishing out the pre-trim process on a glass table. The holes are useful as trim guides for cutting precise holes in film to fit cleanly around circular hinge bolts and other hardware found on movable vent wings and swing-out rear quarter windows.

Film Handler 72" (AT-911)

Used for making precise horizontal and vertical cuts in window film from any roll width up to a maximum of 72 inches. It has at least 2 vertical slitters for rapid, simultaneous cutting of narrow strips for multi-piece rear windows. Slitting injector blades are hidden and recessed for safety. Can be affixed to a six-foot aluminum step-ladder for in-shop or on-location cutting at commercial job sites. An essential professional tool to reduce waste and speed installations with straight & square cuts on all four sides. (Ladder not included.) This is a special order item, please call for availability.

Film Handler Assembly (AT-912)

This is the blade holder assembly for the Film Handler (AT-911). This is a special order item, please call for availability.

12" Risers (AT-913)

12" risers and 6" core adapter set for the Film Handler AT-911. This is a special order item, please call for availability.

Box Slitter Channel (AT-822)

72 inch-aluminum U-channel for sliding over the edge of a film box-top to serve as a straight edge when making horizontal cuts (across the web width) after pulling film out to desired length. Handy for in-field work. Saves the cost more expensive film cutters. This is a special order item, please call for availability.

Blade Holders (AT-821)

Used with the AT-822. These devices enable razor blades to be attached to the Box Slitter Channel to permit vertical cuts up the roll as the film is pulled from the box. Thumbs screws loosen/tighten to allow blade holder to be slid to any position along the channel. This is a special order item, please call for availability.